WHY SHOULD I USE THIS SEAL STRIPS？
WHY SHOULD I USE THIS SEAL STRIP
1. The voice is steady and heavy when switch the car door, eliminate collide sound when closed the car door.
2. Inhibition of high-speed wind dry, reduce interior noise
3. Improve vehicle's air-tightness and dust-proof capabilities.
4. The optimization engine compartment cooling airflow.
5. Improve the air conditioning cooling and heating power, to some extent reduce fuel consumption.
- ⭐ --This weatherstripping enhances the leakproofness of your car, which makes the door close more tightly. Reduce the noise of wind when you drive your car at high speed. Make your car more sealed so that you could keep your car away from dust, raindrop, and Fog.
- ⭐ -- High-Quality weatherstripping. It will seal the gap between the car door, car body, car hood, bed rail, etc. Enhance driving comfort while cruising on the highway. Excellent soundproof compression set resistance for maximum service life and vibration absorption.
- ⭐ --An upgraded universal car truck sealer weather striping used to replace other Type D, P, Z, and O stripe. Easy to install and high strength adhesive seal. You just need to push the stripping foam on the rubber sealant above the installed place.
【 Noiseproof 】The voice is steady and heavy when switch the car door, eliminate collide sound when closed the car door.
【 Windproof 】 Inhibition of high-speed wind dry, reduce interior noise, can be controlled 120M/H into 80M/H.
【 Dustproof】Improve vehicle's air-tightness and dust-proof capabilities.
【 High and low-temperature resistant】The optimization engine compartment cooling airflow. Improve the air conditioning cooling and heating power, to some extent reduce fuel consumption.
【Safe】Non-toxic and no risk of air circulation in the car.
The best in the market.This new generation B type car seal strip upgraded product to replace D, P, Z and O type car seal strip. With one strip, you could do all.
1.Wipe away stains, dust, and oil at the installation site with a dry cloth
2.Peel the protective film at one end of the seal strip.
3. After placement, press seal firmly.
4. Do not wet wash for 3 days, within 24 hours try not to open the door repeatedly
5. After installation is complete, the door will be a bit tight, will return to normal in about 2-3 days.
It will seal the gap between the door, car body, car hood, bed rail, etc. You can use them on the engine cover, trunk box, and doors.
- For engine cover: 32ft/10m rubber strip
- For 4 car doors: 52ft/16m long rubber strip
- For 4 car doors and engine cover: 68ft/20m long rubber strip
- For 4 car doors engine hood and trunk box: 84ft/25m long rubber strip
Extreme temperatures will result in poor adhesive performance. Apply this seal only if the air and surface temperature is between 55°- 104°F(13° - 40°C). If 45°-54°F(7° - 12°C) you can use a hair dryer and warm the tape and surface of pickup 6in (15cm)section at a time, then apply.